Make it step by step
See second photo below.
Make one career passes tapes (* 1 dc, ch 1, skip 1 basis point *, and repeat *)
In other career do 2 dc, ch 1, 2 dc on the basis of one current and jump 1 square of base
To do this gloves you need needle 1 and 2. I used the two then u will see why. (Here in the beginning used the number of needle 1.) The needles used for this thread: -Tulip 1 (1.6 mm) to start -1-2.00 mm to the closing on the gloves and sides. In these two photos below did 40 little chains and returned making 1 dc in each stream. I did so by 4 rows.
After already the fifth (5th) career back doing 28 high points, leaving the final 12 waiting to do the little finger later.
When making the 5th round (fifth round), taking advantage of the box part of the very end you can do as I did (28 closed lower half point together) with a needle as many crochet, (I used the number 2) I gave one point (1 current), and 1 loop as if it were making a high point, but only of the loop and pull the next point without closing it leaving close them all at the end to tighten and close the gloves up
Once they are all on the needle pull a loop by the end closing every point.
After closing the 28 points, make one point very low at the other end of luvinha to close the ladinho.
see how is closed and you will then closing the side with lows until you reach the part of the little finger.
Change the needle to the corresponding number for your yarn (mine is number 1) and make three little chains to keep the part of the little finger. Note that already with the closed side.Then make 3 rows of high points.
(Do not forget we're working on the side of the WS)
To close above the little finger do the same procedure - one current and one loop, the other half high point without closing the ending point all at the end of his career.
Are 12 half point higher closed together . To facilitate change the needle to a higher number.
Here already closed, then turn to make one point very low and continue closing the luvinha with very low points.
Here already closed little finger.
Turn to the right side.
Make one career passes tapes (* 1 dc, ch 1, skip 1 basis point *, and repeat *)
In other career do 2 dc, ch 1, 2 dc on the basis of one current and jump 1 square of base.
In other career do 2 dc, ch 1, 2 dc on the basis of one current and jump 1 square of base.
Do more with a career peak the first half of the fans and finally a separate chain on 80 points, or use a tape to put on tape passes, and is ready to gloves
To make the other gloves is the same procedure, only care at closing time, turn the lock side to the pinky get to the other side.
Thank your
:)
:)
Comments
Post a Comment
THANK YOU